Specifications; Parts And Accessories - Snapper ELT RD Serie Manual Del Operador

SPECIFICATIONS

ENGINE
18 HP* Briggs & Stratton
Make Briggs & Stratton
Horsepower 18 @ 2700 +/- 100 rpm
Displacement 40.03 cu in. (656 cc)
Electrical System 12 Volt, 16 amp Alternator, Battery: 230 CCA
Oil Capacity 62-64 oz (1,8-1,9 L)
Spark Plug Gap 0.030 in. (0,76 mm)
Spark Plug Torque 180 in-lbs (20 Nm)
24 HP* Briggs & Stratton
Make Briggs & Stratton
Horsepower 24 @ 2700 +/- 100 rpm
Displacement 44.18 cu in. (724 cc)
Electrical System 12 Volt, 16 amp Alternator, Battery: 230 CCA
Oil Capacity 62-64 oz (1,8-1,9 L)
Spark Plug Gap 0.030 in. (0,76 mm)
Spark Plug Torque 180 in-lbs (20 Nm)
Service Parts Part Number
Resistor Spark Plug 491055
Life Long Platinum 5066
Spark Plug
Air Filter 499486
Pre-Cleaner 273638
Oil Filter 492932
Fuel Filter 691035
CHASSIS
Fuel Tank Capacity Capacity: 2.6 gal (10 L)
Rear Wheels Tire Size: 22 x 8.8
Inflation Pressure: 10 psi (0,68 bar)
Front Wheels Tire Size: 15 x 6.6
Inflation Pressure: 14 psi (0,96 bar)
*The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive Engi-
neers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained and cor-
rected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values are
derived at 3600 RPM. Actual gross engine power will be lower and is affected by, among other things, ambient operating
conditions and engine-to-engine variability. Given both the wide array of products on which engines are placed and the vari-
ety of environmental issues applicable to operating the equipment, the gas engine will not develop the rated gross power
when used in a given piece of power equipment (actual "on-site" or net horsepower). This difference is due to a variety of
factors including, but not limited to, accessories (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), appli-
cation limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine variability. Due to
manufacturing and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power for this Series en-
gine.

PARTS AND ACCESSORIES

Replacement Parts
We recommend that you see any authorized
Snapper/Briggs & Stratton Dealer for all maintenance and
service of the tractor/engine and parts.
32
TRANSMISSION
K46
Type Hydrostatic Tuff Torq K46
Engine Oil Synthetic 5W30
Speeds Forward: 0-5.4 MPH (0-8,7 km/h)
@ 3400 rpm Reverse: 0-2.3 MPH (0-3,7 km/h)
Continuous Torque 170 ft-lbs
Output
Drawbar Rating 227 lbs (103 kg)
Maximum Weight 675 lbs (306 kg)
on Axle
MOWER
Width of Cut 40" (102 cm)
Number of Blades 2
Base Deck Platform Rear Discharge
Cutting Height 0.98-3.15 in. (2,5-8.0 cm)
Cutting Positions 7
DIMENSIONS
Overall Length 79.9" (2030 mm)
Overall Width 42.1" (1070 mm)
Height 46.9" (1190 mm)
Weight 595 lbs (270 kg)
Accessories
The following accessories are available for this machine.
Contact an authorized Snapper Dealer for details:
Dozer Blade, 42"
Dump Cart
Rear Deflector
Rear Weight Carrier
Rear Wheel Weights, 31 lbs
Single Stage Snowthrower
Snow Cab
www.snapper.com