Publicidad
5. Repair and adjustment
5. Réparations et réglages 5. Herstellen en afstellen
5. Riparazioni e messa a punto 5. Reparación y ajuste
1. Handle (low position)
GB
2. Handle (high position)
3. Handle lock lever
4. Belt guide "B"
5. Belt guide "A"
6. Engine pulley
7. Idler pulley
8. Extention spring
9. Transmission pulley
10. Drive control cable
11. Cable clip screw
Figure 16
1
2
3
5. Reparatur und Einstellung
Position handle
Loosen handle lock lever (fig. 16). Handle can be
positioned at different settings between "high" and "low"
positions (fig. 16). Retighten handle lock lever.
NOTE!
Select handle height suitable for you and your tilling
conditions. Handle height will change when tiller digs
into the soil.
WARNING!
Stop the engine and remove the spark plug wire and
cover from the spark plug (fig. 7) before cleaning out the
tines by hand. Use caution - tines are sharp.
CAUTION!
Place blocks under transmission to keep tiller from
tipping.
Ground drive belt adjustment
For proper belt tension, the extension spring (fig. 17)
should have about 5/8 inch stretch with drive control bar
in engaged position (fig. 9). This tension can be obtained
as follows.
a.
Loosen cable clip screw securing the drive control
cable (fig. 17).
b.
Slide cable forward for less tension and rearward
for more tension until about 5/8 inch stretch is
obtained.
c.
Tighten cable clip screw securely.
Figure 17
6
8
7
53
11
10
4 5
9
Publicidad
