Assembly Steps - FITFIU FITNESS BP-20 Manual Usuario

ASSEMBLY
GENERAL SET-UP INFORMATION
• The assembly should be done by two aduits if possible. Carefully read the manual and look at the explanatory
drawing on previous page before starting setting the item up.
• Remove all packaging material and spread all parts onto an even surface to get an overview and facilitate the assembly.
Protect the set-up area ground by using any kind of cover.
•
Check all parts listed in the parts' list are included. Do not dispose of the packaging material until the assembly
is completed.
• Note: When using tools a danger of injury exists. Use caution and keep the work environment as risk-free as
posslble. Dispose of foils or plastic bags that pose a choking hazard to children.
• Note: Sorne of the screws are already in the respective holes; please loosen them before performing the appropriate
installation step. Also note the "L" (left) and "R" (right) markings for the correct structure.
• Only the supplled tool is requlred to set-up the item.

ASSEMBLY STEPS

NOTE
Don't fully tighten all boits before the entire unit has been completely assembled.
STEP I
A. Place the two upright components (05 R&L) on a level floor and place the rear cross tube (06) in between the
two upright assemblies. lnsert four half threaded hex head boits (42) along with four washers (37-1) through
the upright assembly (05 R&L) into the rear cross tube (06) as shown. Secure the upright assembly (05 R&L)
and rear cross tube (06) with four washers (37) and tighten with four nylon nuts (49).
B. Place the backrest holder adjustment tube (07) between the two upright assemblies (05 R&L).
49
WEIGHT BENCH BP-20
EN