Before Using This Product - FITFIU FITNESS BP-20 Manual Usuario

BEFORE USING THIS PRODUCT

SETTINGS
Always be careful when mounting the item. Keep your
balance at all times.
HEIGHT ADJUSTMENT OF THE BARBELL
HOLDERS
The height adjustable barbell holders (adjusta ble
heights approx. 119.5 I 126.5 I 133.5 I 140.5 cm) are
secured by the shown knob screws. To adjust the
height, first remove the barbell if available and place
this safely on the ground. Then loasen the safety
screws and pull those out of the holders.
Adjust the height of the barbell holders (make sure
both sides are set at the same height), push the
safety pin back into the holes and fix the safety pin
screw again.
HEIGHT ADJUSTMENT OF THE
BACKREST
The backrest is lying on top of the shown cross bar
when set horizontally or in any of the lower positions.
it is secured by the safety pin when put into the
almost vertical positions at 67° or 85° (please refer to
the detail pictures below).
The horizontal crossbar may be adjusted in four
different height positions in between the verti cal
barbell holders (heights approx. 35 I 47 I 60 I 75 cm).
In order to adjust the position, lift the backrest until
a vertical position and secure it with the safety pin.
Then take the crossbar and insert it into the holders
attached to the verti cal barbell holders where desired.
Make sure you select the same height on both sides!
Then pull out the safety pin and lower the backrest
onto the crossbar again.
54