Battery Installation/Replacement; Preparation Before Taking A Measurement - Medline MDS4001 Manual De Usuario

PREPERATION BEFORE TAKING A MEASUREMENT

Battery Installation/Replacement

1. Slide the battery cover off in the direction of the arrow.
2. Install or replace the four alkaline "AA" batteries, noting the
proper orientation of positive (+) and negative (-) terminals
in the battery compartment.
3. Replace the battery cover.
4. If the Low Battery Symbol appears on the display,
replace the batteries.
5. Remove the batteries if the device will not be used for
an extended period of time.
How to Apply the Arm Cuff
1. Insert the end of the cuff through the D-Ring to make a loop.
(Make sure that the hook and loop closures stays outside
when it is done.)
2. Wear the arm cuff with the hose downward. Pull the end of
the cuff and secure it snugly with the hook and loop closures
3. Adjust the cuff so that the bottom edge is about 1 inch above
the elbow on the inside of the arm. Make sure the colored
area on the cuff covers the brachial artery.
4. Plug the air tube connector into the monitor.
Note: Batteries are hazardous waste.
Do not dispose with household garbage.
8
Step 1
brachial artery
Step 3
Step 2
Step 4