Premium Led (Optional); Dental Chair; Zero Position; Work Position - Olsen Logic Plus Guía De Operación

5.7.2 - Premium LED (Optional)

To activate the operating light: press the On/Off operating light
command (1) on the command panel (section 5.4 and 5.6) or remote foot
pedal (section 5.3) to enable sensor (5) and control knob (4).
To turn On/Off the operating light: pass the hand in front of the
sensor (5) approximately 5 cm away or press the control knob (4).
To change the light intensity: hold your hand in front of
the sensor (5) or turn the control knob (4) until the operating
light shows the desired intensity.

- Dental Chair

To move backrest and seat use the keys on the command panel (section 5.4 and 5.6) and in the buttons
located on remote foot pedal (section 5.3).

5.8.1 - Zero Position

Press the Zero Position key to automatically adjust the seat to the lowest position and
backrest in the highest position simultaneously, to facilitate patient entry and exit.

5.8.2 - Work Position

To save a work position:
1º - Press the Zero Position key (section 5.8.1);
2º - Adjust the backrest to the desired position;
3º - Adjust the seat to the desired position;
4º - Press the Work Position key for 5 seconds. The equipment will emit 2 long beeps;
5º - Press command 1 (Seat Up) while the equipment beeps; The equipment will emit 2 short beeps to confirm
the procedure;
Note: the time to record the working position is only 2 seconds between steps 4 and 5, then when you hear the
first long beep (step 4), quickly press one of the available commands (1 to 3) to record the working position. If
none of the available commands are pressed during this time, the equipment will emit 3 short beeps, canceling
the operation.
6º - Press the Zero Position key (section 5.8.1).
Repeat the previous steps by replacing the command 1 by the command 2 (Backrest Up) to record the
working position 2 or by the command 3 (Seat Down) to save the working position 3.
To perform a working position:
1º - Press the Work Position key; The equipment will emit a short beep;
2º - Press the command for the desired saved working position (1 to 3); The equipment beeps twice confirming
the operation.
The dental chair moves the backrest and seat simultaneously to the previously saved position and lights
the operating light at the last intensity used.
Note: after pressing the Work Position key, the time for position selection is 4 seconds. If no key is pressed within
this time, the equipment cancels the operation.

5.8.3 - Spit Position

To perform a spit position:
1º - Press the Work Position key (section 5.8.2);
2º - Press the command 4 (Backrest Down).
The equipment emits 2 beeps, turn Off the operating light, the backrest goes up and activates the water in
the bowl. After 8 seconds, the equipment returns to the position before the command.
Note: the spit position is pre-recorded at the factory and cannot be changed.
Seat Up ( )
Backrest Up ( )
13
Seat Down ( )
Backrest Down ( )