High Power Vórtice Saliva Ejector (Optional); Vacuum Pump Adaptor (Optional); Way Syringe; Scaler With Led Light (Optional) - Olsen Logic Plus Guía De Operación

- High Power Vórtice Saliva Ejector (Optional)
Before starting the operation with the Vórtice saliva ejector (2),
insert the cannula into the  6,3, 9,5 or 11 mm adapter (3).
To enable/disable suction: use the On/Off Vórtice saliva ejector
button (1) on the remote foot pedal (section 5.3).
The cannula adapter (3) is removable for cleaning.

- Vacuum Pump Adaptor (Optional)

Before starting the operation with the Vacuum Pump saliva ejector (2),
insert the cannula into the  6,3, 9,5 or 11 mm adapter (5).
To activate suction: remove the vacuum pump suction (2) from its
holder (1). The vacuum pump will work automatically.
To adjust suction flow: to decrease the suction flow, turn the adaptor's
body (3) away from the indicators (4). The more distant, the smaller the
suction. For the maximum suction flow, align the indicators (4).
To deactivate the suction: place the vacuum pump in its holder (1).
The cannula adapter (5) is removable for cleaning.

- Way Syringe

Before beginning the use of the 3-way syringe (5), connect the
syringe tip (3) by pressing the locking ring (4) into the correct fit.
To emit air jet: press the air button (1).
To emit water jet: press the water button (2).
To emit spray jet: press simultaneously the air (1) and water
buttons (2).

- Scaler with LED Light (Optional)

Before starting the scaler operation, install the tip on
the transducer and connect the transducer (1) to the
coupling (3) verifying if there are no leakages between both
parts.
To attach the transducer to the coupling: align the
adjustment indicators (2) of the two parts and carefully
insert them.
To install the scaler tips: insert the tip into the
transducer by threading it carefully, then insert the Torque
wrench (4) into the tip and then rotate it clockwise until it is
tight. To remove the tip, turn it counterclockwise with the
Torque wrench (4).
To install a file adapter (not supplied with scaler): attach the adapter to the transducer (1) and screw it
gently. Insert the file into the tip of the adapter, thread the tip and then use the Endo wrench (5) to tighten. To
remove the adapter, use the Endo wrench (5) to loosen it and then carefully unscrew.
15