Curing Light; Accessory Operation; Multifunctional Display (Optional); Chronolub System (Optional) - Olsen Logic Plus Guía De Operación

- Curing Light

Before starting the curing light use, install
the tip (1) and the light hood (2).
To install the tip (1): first, attach the light
hood (2) to the tip (1) and then attach it to the
curing light unit (3). The tip (1) must be pushed all
the way to the fitting end.
To activate/deactivate the curing light: press the On/Off button (5) twice. The
green LED (4) indicates that the curing light is operating. The curing light unit will
run for 20 seconds and will turn Off automatically.
To toggle the operating mode: each tap on the selection button (9) switches
the operation mode. Press the selection button (9) until the orange LED indicates
the desired mode.
The curing light operates in the following modes:
− Continuous (6): turns on the maximum power for 20 seconds;
− Ramp (7): turns on the minimum power, gradually increasing. In 5 seconds
reaches its maximum power until the cycle of 20 seconds is finished;
− Pulse (8): the device blinking for 20 seconds.

- Multifunctional Display (Optional)

1 - Decreases
2 - Increases
3 - Adjust/Enter
4 - Reset/Esc

7.1.1 - ChronoLub System (Optional)

When removing the handpiece from the holder or extending the rod (Cross Flex) the multifunction display
will identify whether the coupling is for low or high rotation, show the number of
its position on the working table (1 to 5), and a segmented circle that represents
the time of use of the handpiece. When the last segment starts blinking, the
handpiece can be used for another 2 minutes.
When you run out of time, the screen will show a spray can and will emit 3
beeps. From this moment whenever the handpiece is removed from the holder, the
system will beep, repeating the warning every 2 minutes while the handpiece is in
use or out of the holder.
After lubricating the handpiece, with it out of the holder, or with the extended
rod (Cross Flex), press the Reset/Esc key (4) for 3 seconds to restart the timing.
This procedure can be done at any time.

7.1.2 - Clock - Date and Time (Optional)

To access the Clock function: press the Adjust/Enter key (3) for 3 seconds
to access the "AJUSTE" screen. Use the adjustment keys (1 and 2) to select the
"1. RELÓGIO" option.
To adjust the clock: press the Adjust/Enter key (3) to access the "AJUSTAR
O RELÓGIO" screen. Use the adjustment keys (1 and 2) to change the selected
value.
To toggle the selection between hour, minute, day, month and year: use
the Adjust/Enter key (3).
To save the changes: press the Adjust/Enter key (3) for 3 seconds.
To cancel and return to the previous screen: press the Reset/Esc key (4).

7 - Accessory Operation

20