Du Pont WFDW12000 Serie Instrucciones De Instalación página 5

STEP 3
Connect Water Lines
FOR RIGID TUBING:
1
Disconnect the bottom of the cold water plumbing line from the shut-off valve and gently bend the plumbing line for access to the
lower line fitting.
2
Screw the 3/8" Male OD Adaptor
3
Screw the 3/8" Female OD Adaptor
FOR FLEXIBLE TUBING:
1
Disconnect the bottom of the cold water plumbing line from the shut-off valve.
2
Screw the 3/8" Male OD Adaptor
3
Screw the 3/8" Female OD Adaptor
STEP 4
Connect the 1/4" Plastic Tubing
FROM SYSTEM HEAD INLET TO 3/8" FEMALE OD ADAPTOR:
1
Determine the length of 1/4" Plastic Tubing
Adaptor at the shut-off valve. Make sure to allow enough 1/4" Plastic Tubing to prevent kinking in the line.
2
Cut the 1/4" Plastic Tubing squarely on both ends.
3
Wet one end of the 1/4" Plastic Tubing with water and push it into the System Head Inlet until it stops.
NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting.
4
Wet the other end of the 1/4" Plastic Tubing with water and push it into the 3/8" Female OD Adaptor until it stops.
NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting.
FROM SYSTEM HEAD OUTLET TO 3/8" MALE OD ADAPTOR:
5
Determine the length of 1/4" Plastic Tubing
on the lower end of the plumbing line. Make sure to allow enough 1/4" Plastic Tubing to prevent kinking in the line.
6
Cut the 1/4" Plastic Tubing squarely on both ends.
7
Wet one end of the 1/4" Plastic Tubing with water and push it into the System Head Outlet until it stops.
NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting.
8
Wet the other end of the 1/4" Plastic Tubing with water and push it into the 3/8" Male OD Adaptor until it stops.
NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting.
Universal Drinking Water Series
E
onto the compression fitting on the lower end of the plumbing line.
F
onto the cold water shut-off valve outlet port.
E
onto the existing nut on the lower end of the flexible hose.
F
onto the cold water shut-off valve outlet port.
D
that will be necessary to connect the System Head Inlet to the 3/8" Female OD
D
that will be necessary to connect the System Head Outlet to the 3/8" Male OD Adaptor
3
4
4
1
COLD WATER
VALVE
2
3
E
INLET
D
A
3
4
D
INLET
A
F
8
E
D
RIGID
TUBING
F
OUTLET
7
OUTLET
V4.0