Du Pont WFDW12000 Serie Instrucciones De Instalación página 7

If Installing an Optional Faucet for Filtered Water:
NOTE: Final filters reduce water flow. If you wish to maintain unfiltered water flow for dishwashing, etc., we recommend installing
a separate Faucet for Filtered Water (DuPont WFFT100 Series).
STEP 1
Mount the Faucet for Filtered Water (Not Included)
NOTE: Most standard sinks come with 1-3/8" or 1-1/2" diameter water sprayer holes that can be used for mounting the Faucet. If the pre-drilled
holes cannot be used or are not in the desired position, a new hole must be drilled using either a 9/16" or 5/8" drill bit to accommodate the
Faucet. The Faucet for Filtered Water base should be positioned securely on a flat surface with adequate space for proper function. Consider
convenience and appearance of the faucet before installation.
IF YOUR SINK DOES NOT HAVE A WATER SPRAYER HOLE, GO TO
1
In order to prevent parts and materials from falling down the drain, line the sink with newspaper or a towel.
2
Apply masking tape to the area to be drilled in order to prevent scratching the sink surface or countertop if the drill bit slips
during operation.
3
Using a center punch, mark the drill hole. Use the 1/4" drill bit to make a pilot hole. Then use the 9/16" or 5/8" drill bit to drill the final
hole. Drill completely through the sink or countertop and smooth the rough edges with a file.
C C A A U U T T I I O O N N
Safety glasses and a respirator are
recommended for this process, as it
may produce dust that can cause
severe irritation if it is inhaled or
comes in contact with eyes.
4
Mount the faucet for filtered water according to the installation instructions that came with the faucet you purchased.
STEP 2
Install the Kitchen Faucet Adapter (Not Included)
NOTE: Our DuPont™ WFFT100 Series Faucets for Filtered Water come with a Kitchen Faucet Adapter.
1
Locate the cold water shut-off valve underneath the sink. Turn off the cold water supply to the kitchen faucet.
NOTE: If uncertain about which line supplies the cold water, turn on the hot water to the faucet. Allow the water to heat up and carefully
feel the pipes under the sink. The pipe that remains cool to the touch is the cold water supply.
2
Turn on the cold water on the kitchen sink to release pressure and allow water to completely drain from the line.
Universal Drinking Water Series
1
. IF YOUR SINK DOES HAVE A WATER SPRAYER HOLE, GO TO
N N O O T T I I C C E E
DO NOT DRILL THROUGH AN ALL-PORCELAIN OR CAST IRON SINK. If installing on an all-porcelain
or cast iron sink, the faucet must be mounted in a pre-drilled sprayer hole or through the countertop
next to the sink. If the countertop must be drilled, make certain that the area below the drilling
location is free of wiring and pipes. Also, make sure that there is sufficient room to make the proper
connections to the bottom of the faucet mount. DO NOT DRILL THROUGH COUNTER TOPS MORE
THAN 1" IN THICKNESS OR COUNTERTOPS MADE OF TILE, MARBLE, GRANITE OR SIMILAR
SUBSTANCE. Consult with a plumber or the countertop manufacturer for assistance.
1
4
.
2
continued to next page
6
FAUCET FOR
FILTERED WATER
(not included)
KITCHEN FAUCET
HOT WATER COLD WATER
VALVE VALVE
KITCHEN FAUCET
2
4
3
6
HOT WATER COLD WATER
VALVE VALVE
X
5
X
RIGID TUBING INSTALLATION
V4.0