Publicidad
Idiomas disponibles
Idiomas disponibles
THE ILLUSTRATIONS MAY NOT DEPICT YOUR EXACT MODEL DESIGN
4. Installation on Emerson Fans Having
Two-Piece Die-Cast Switch Housing (continued)
4.8
Insert the Light Fixture Assembly Chain and the Fan
Speed Control Switch Chain through the Holes in the
Glass Bowl (Figure 19).
Gently place the Glass Bowl onto the Light Fixture
Assembly (Figure 19).
Secure the Glass Bowl by installing the Rubber Washer
and Thin Hex Nut finger tight on the Light Fixture
Assembly Threaded Shaft (Figure 19).
NOTE: It is advisable to periodically check the
tightness of the thin hex nut.
NOTE: It is critical that the fan chain(s) are aligned
with hole(s) in the shade and bowl cap for smooth
operation of the fan switch(es).
4.9
NOTE: The FN200 pack comes with three bowl cap
options: no holes, one hole and two holes for pull
chain options.
Place the Bowl Cap (for your application) onto the Light
Fixture Assembly Threaded Shaft.
Route the Fan Speed Control Chain through the Bowl
Cap Outer Hole (Figure 20).
Route the Light Fixture Assembly Control Chain
through the Bowl Cap Center Hole (Figure 20).
Install and tighten the Finial Nut onto the Light Fixture
Assembly Threaded Shaft (Figure 20).
NOTE: It is critical that the fan chain(s) are aligned
with hole(s) in the shade and bowl cap for smooth
operation of the fan switch(es).
THREADED SHAFT
LED LIGHT FIXTURE
ASSEMBLY CHAIN
RUBBER WASHER
THIN HEX NUT
Figure 19
THREADED
SHAFT
BOWL CAP
LIGHT FIXTURE
ASSEMBLY
CONTROL CHAIN
Figure 20
13
FAN SPEED
CONTROL CHAIN
GLASS BOWL
OUTER HOLE
CENTER HOLE
FINIAL NUT
FAN SPEED
CONTROL CHAIN
emersonfans.com
Please contact 1-800-654-3545 for further assistance
LK150OM U.L. Model No.: PH334
LK180 ETL Model No.: LK180
GLASS
BOWL
Publicidad
