Publicidad
Idiomas disponibles
Idiomas disponibles
3. Installation on Emerson Fans Having a
Modular Switch Housing with Center Screw
3.12
NOTE: The FN200 pack comes with three bowl cap
options: no holes, one hole and two holes for pull
chain options.
Place the Bowl Cap (for your application) onto the Light
Fixture Assembly Threaded Shaft.
Route the Fan Speed Control Chain through the Bowl
Cap Outer Hole (Figure 11).
Route the Light Fixture Assembly Control Chain
through the Bowl Cap Center Hole (Figure 11).
Install and tighten the Finial Nut onto the Light Fixture
Assembly Threaded Shaft (Figure 11).
NOTE: It is critical that the fan chain(s) are aligned
with hole(s) in the shade and bowl cap for smooth
operation of the fan switch(es).
3.13
Depending on the Model Purchased: Connect the
Pendant (supplied) to the Fan Speed Control Chain by
sliding the Pendant (small hole first) up onto the Fan
Speed Control Chain (Figure 12).
Then attach the Coupling (supplied) to the end of the
Fan Speed Control Chain and allow the Pendant to fall
down over the Coupling (Figure 12).
Connect the Pendant (supplied) to the Light Fixture
Assembly Control Chain by sliding the Pendant (small
hole first) up onto the Light Fixture Assembly Control
Chain (Figure 12).
Then attach the Coupling (supplied) to the end of the
Light Fixture Assembly Control Chain and allow the
Pendant to fall down over the Coupling (Figure 12).
THREADED
SHAFT
BOWL CAP
LIGHT FIXTURE
ASSEMBLY
CONTROL CHAIN
Figure 11
LIGHT FIXTURE
ASSEMBLY
CONTROL CHAIN
Figure 12
9
(continued)
GLASS BOWL
OUTER HOLE
CENTER HOLE
FINIAL NUT
FAN SPEED
CONTROL CHAIN
GLASS BOWL
FAN SPEED
CONTROL CHAIN
PENDANT (2)
COUPLING (2)
emersonfans.com
Please contact 1-800-654-3545 for further assistance
LK150OM U.L. Model No.: PH334
LK180 ETL Model No.: LK180
Publicidad
