Operation; How To Start Engine - Pulsar PG4500iSR Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Standard Atmospheric Conditions
Ambient Temperature: 77ºF (25ºC)
Barometric Pressure: 750 mmhg
Relative Humidity: 30%
Generator output will vary due to changes in temperature, altitude, and humidity. If the temperature, altitude, and humidity
are higher than standard atmospheric conditions, the generator's output will be reduced.
How to Start Engine - Manual Start
Place generator on a level surface. All electrical loads MUST be disconnected from generator.
Battery ON/OFF Switch to "ON" position
Turn the FUEL VALVE Knob to "ON"
Pull the recoil starter grip slowly until resistance is felt; retract, then pull rapidly.
Manual Start
ON
OFF
How to Start Engine - Push Button Start & Remote Start
Place generator on a level surface. All electrical loads MUST be disconnected from generator.
Battery ON/OFF Switch to "ON" position
Turn the FUEL VALVE Knob to "ON"
Push the One Push Start Button until generator starts. Remote Start: push the control Start button until the engine
starts.
(make sure battery is connected)
Pull cord recoils rapidly and can pull arm towards engine faster than you can let go could result in
injury.
Pull starter cord slowly until resistance is felt; retract, then pull rapidly.
Note:
To start the generator with the Economy switch in the "ON" position
Disconnect all electrical loads from generator.
If ambient temperature is below 32ºF (0ºC) allow about 3 minutes for the engine to warm up.
With the Economy switch in "ON" position, the unit returns to normal operation after the above warm up time.
Economy switch must be in the "OFF" position when using electrical devices that require a large starting current, such
as an air compressor.

OPERATION

ON
OFF
Push Button Start & Remote Start
13
or
START
or
STOP

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido