End Of Operation - diversey TASKI procarpet 45 Manual De Instrucciones

End of operation

• Release the operating lever.
• Switch off the machine (main switch).
• Push the foot pedal backwards to lift
the suction nozzle and cylindrical
brush.
If parked with lowered tools, the "suc-
tion nozzle and cylindrical brush"
may be damaged.
• Remove the plug from the mains socket.
• Clean the power supply cord with a
damp cloth and sling the cord loosely
around the guide bar.
Notice:
All components that must be cleaned are
marked with yellow maintenance circles.
Empty and clean the recovery and fresh
water tanks after every use.
Stale water will result in unpleasant odors
and accumulation of dirt within just a few
hours.
Emptying the recovery tank and fresh water tank
Notice:
Drain water or cleaning solution must be
disposed of in compliance with the nation-
al regulations.
Notice:
When draining the recovery tank, the reg-
ulations of the detergent supplier regard-
ing personal protective equipment must be
observed.
Notice:
The tank may not be removed from the
machine while completely full.
Empty recovery tank
• Move the machine to a suitable drain.
• Remove the drain water hose from
the holder.
• Fold the neck (1) of the hose.
1
• Insert the drain hose for dirty water into the drain.
• Remove the lid carefully and empty the recovery tank.
Empty fresh water tank
• Move the machine to a suitable drain.
• Take the drain hose for fresh water
from the holder.
• Insert the drain hose for fresh water into the drain.
• Remove the blue lid carefully, tilt the machine backwards
slowly to empty the fresh water tank completely.
Emptying the fresh water tank (with additional drain
hose)
Notice:
The additional drain hose is intended as
further help for emptying the fresh water
tank if no floor drain is available.
Notice:
Stay with the machine until the emptying
process is completed.
• Move the machine to a suitable drain.
• Plug the additional drain hose into
the plug-in coupling.
• Insert the additional drain hose into the drain.
• Turn the machine (pump) on (main switch).
• Empty the fresh water tank.
Notice:
Turn the machine off immediately when no
more water is flowing out.
Turn the machine (pump) off (main
switch).
Attention:
The pump must not run dry.
Dry running may cause damage.
EN
71