Troubleshooting; Replacement Parts And Accessories - red lion RL25U El Manual Del Propietario

MAINTENANCE

Troubleshooting

Troubleshooting
Problem
Pump not plugged in.
Circuit breaker off or fuse removed.
Pump does not
Corroded power cord plug prongs.
turn on
Tripped overload.
Defective motor.
Blocked or jammed impeller.
Pump runs but
Suction lift is too high.
does not dis-
charge fluid
Inlet to impeller plugged.
Lift too high for pump.
Pump does not
Partially blocked inlet.
deliver rated
Impeller or discharge pipe is clogged.
capacity
Impeller wear due to abrasives.

Replacement Parts and Accessories

If products are not available at your local retailer, contact Technical Service at 888.885.9254 for ordering
information.
Item Part Number
1 14942729
2 599002
3 599304
4 14942904
5 640171
For technical assistance, parts, repair, or warranty information, please contact:
888.885.9254 | redlionproducts.com
Form 998777 Rev. 000 01/20
Probable Causes
1
2
5
Discharge/Adapter Kit contains 3/4" discharge, seals, hardware and 1-1/4" FNPT adapter
SA-1 Sacrifical Anode (Optional accessory)
Universal 24' Hose Kit with 1-1/4" and 1-1/2 adapters (Optional accessory)
Vertical float switch with 10' cord (Optional accessory)
Tethered float switch with 10' cord (Optional accessory)
Corrective Action
Connect pump power cord to a GFCI circuit.
Turn on circuit breaker or replace fuse.
Clean prongs on power cord plug.
Allow pump to cool, investigate cause (i.e. jammed impeller).
Replace pump.
Clean impeller; refer to "Maintenance" on page
Reduce the pump height to water source.
Pull pump and clean, refer to
Check rated pump performance.
Clean inlet.
Pull pump and clean. Check hose for kinks or blockage.
Replace pump.
3
4
Description
3.
"Maintenance" on page 3
Copyright © 2020, Franklin Electric, Co., Inc. All rights reserved.