Safety And Operating Instructions - Etherma solamagic S1 Instrucciones De Montaje Y Uso

Safety and operating instructions

Please observe the following instructions:
• Carefully read through the instruction manual prior to installation and store the
manual safely.
• This heater is intended for outdoor installation, either attached to a building
wall or some other solid construction. It is not intended to be used indoors to
provide heating up to a pleasant temperature level.
• The heater must only be used by adults. Children must not play with the heater.
Children younger than 3 years old must be kept away from the heater unless
they are continuously monitored.
Caution - Some parts of this product can become very hot and cause burns.
Special care is required when children and vulnerable persons are present.
• Installation tasks must be properly carried out by a qualified person in ac-
cordance with VDE 0100 installation instructions (if applicable, also including
Parts 559 and 701).
• When carrying out any work, always switch the system to a zero-volt state
(disconnect mains plug; circuit-breaker off). Switch on the heater only after all
the cables have been completely connected.
• The heater must be connected to a switched domestic electrical supply protec-
ted by a fuse of rating at least 16A slow (type C16A).
• Do not install directly under sockets, junction boxes, switches or electrical
cabling.
• Electrical sockets may only be located in the positions specified in Appendix 2.
• Do not mount the radiant heater close to curtains or combustible materials in
accordance with VDE 0100, Part 559.
• The heater is as a minimum compliant to an IP 24 degree of protection, provi-
ded all connectors (heater plug, plugs for expansion components) are plugged
in, and is approved for outdoor use.
• Never leave the heater unattended.
• Do not cover the heater when it is switched on or still hot; there is a risk of fire.
• To adjust the radiation direction, switch the heater off and allow to cool.
• Do not look directly at an operating IR halogen lamp for a long period and from
a short distance.
• IR halogen lamps are sensitive to direct skin contact (do not touch with bare
fingers). Grease or other contamination can be removed with an alcohol-so-
aked cloth.
121
04/2019