Etherma solamagic S1 Instrucciones De Montaje Y Uso página 135

Step 3: Installing the heater on the T-brackets
• Push the securing lugs (3) with the ring (4) from the left side into the dovetail
groove for approx. 530 mm and 130 mm.
• Tighten the 3.5 x 6.5 screws (5).
• Mount the heater (B) in the adapter claws (6). The securing lugs must now be
located directly alongside the adapter claws (6).
• Use a 5 mm Allen key to tighten the eccentric tensioner (7) in a clockwise direction;
the radiant heater must be firmly connected to the adapter claws without any play.
Attention: no screwing stop – do not over-tighten the eccentric tensioner!
• Hang each retaining ring (4) in the adapter claw (A).
• To set or adjust the direction of radiation, use a 5 mm Allen key to loosen the
screws (11), shift the heater into the required direction and re-tighten the screws
(11).
11 6
A
7
B
3,4,5
128
11 6
A
7 3,4,5