Etherma solamagic S1 Instrucciones De Montaje Y Uso página 133

Step 3: Installing the heater on the wall mounting
• Push the securing lugs (3) with the ring (4) from the left side into the dovetail
groove for approx. 170 mm
• Tighten the 3.5 x 6.5 screws (5).
• Mount the heater (B) in the adapter claws (6).
• Use a 5 mm Allen key to tighten the eccentric tensioner (7) in a clockwise direc-
tion; the radiant heater must be firmly connected to the adapter claws without
any play.
• Hang each retaining ring (4) in the adapter claw (A).
• To set or adjust the direction of radiation, use a 5 mm Allen key to loosen the
screws (11), shift the heater into the required direction and re-tighten the screws
(11).
• If the heater cannot be aligned facing downwards, screws (8) to (10) must be
undone and the device pulled out from the bracket. Then remove screws (11)
and refit the middle part with the cloth disc rotated through 180°. Then refit the
device at the wall bracket.
11 6 B
7
126
3,4,5 A
15