Operation; Functioning; Procedure For Operation - Skymsen PSP-98M/T Manual De Instrucciones

Before turning on the machine, make sure that the MOUTH PIN is perfectly
seated in the BOX COVER GUIDE HOLE, and the KNOB is properly tightened. If the
equipment is turned on without the MOUTH being properly fitted and tightened,
the MOUTH may rotate, causing irreparable damage to the equipment, as well as

3. Operation

3.1 Functioning

Turn off the equipment at any time to remove your mouth. The equipment is
silent. Don't let utensils such as knives, hooks and others, about the security Tray.
Make sure that the constituent Assembly of the mouth, is in the correct sequence, as
shown in (fig. 03)
The firing is done as described below:
1 put the plug of the equipment in electric power socket.
2-check that the safety Tray N° 04 (fig. 01) is properly positioned in its place of work;
3-Press the on/off switch N° 06 (fig. 01) to the position "I" making that call equipment.

3.2 Procedure for Operation

Under no circumstances use strange instruments (cutlery, cables, etc.) to push
the product to be rendered to the inside of the mouth, much less your hands. Use
the socket N° 01 (Pic. 01) to do this operation. The product to be rendered inside
the mouth, it has the function to lubricate and cool the components of same.
Therefore, do not leave connected equipment on empty, because in this way, warm
The meat mincer is an equipment that works at high speed and to do so requires that the
power supply is also fast.
To feed him, put the meat on the tray N° 04 Security (Pic. 01), and drive the same with
hands until the entry of the power nozzle. With the help of the socket number 01 (Pic. 01)
push them to the inside of the mouth, where they will be pulled by the worm screw.
IMPORTANT
injuring the operator.
IMPORTANT
IMPORTANT
too, and will damage your components.