Amano American Sanders FloorCrafter Manual Del Operador página 9

EN
Figure 7
Transporting the Machine - One Person
NOTE: This is accomplished by removing the motor from the chassis and
transporting the motor and chassis separately.
To transport the machine, follow this procedure
1. Make sure the power cable is disconnected from the electrical outlet.
2. Release the tension on the drive belts using the quick release lever.
(See Figure 6A )
3. Open the belt guard by pulling on the handle immediately above the
left truck wheel. (See Figure 6B)
4. Remove the drive belts from the machine
5. Disconnect the motor pigtail from motor.
(See Figure 7)
6. Unscrew the motor mounting knobs to loosen the motor.
(See Figure 8)
7. Straddle the motor and grasp the motor lift handle. Using your legs,
lift the motor off the chassis and take it to the work site.
8. Lift the chassis by grasping the front and rear handles. Lift the frame
and bring the belt guard against your chest. Take the chassis to the
work site.
To assemble the machine after transporting, follow this procedure:
1. Open the belt guard door. Place the motor assembly on the chassis
and screw the motor mounting knobs sufficiently to engage and
secure the motor.
2. Install the drive belts. Tighten the belts using the belt tension quick
release lever.
3. Check the tension on the belts and close the belt guard door.
CAUTION: Premature bearing failure can occur if the fan
belt is set too tight. The fan belt should deflect
½" (13 mm) at the center of the span with 5 lbs.
(2,3 kg) of pressure.
NOTE: It is necessary to adjust the fan belt independently during this
procedure or during replacement. The idler pulley is factory adjusted.
:
Transporting the Machine by Carrying - Two People
1. Person #1 lifts the machine by the front handle.
2. Person #2 lifts the machine by the operating handle.
9
Figure 8