Sms Notification Of Low Battery Sensors; Sms Notification Of Tampering Sensors; Sms Notification Of Ac Power Failure And Recovery; Arm & Disarm By Free Phone Call - Smanos X500 Manual Del Usuario

SMS notification of low battery sensors

Control panel: It sends out an SMS "Control panel low battery", meanwhile the LCD
screen flashes once every 1 second to notice user.
Sensor: User will receive SMS "[sensor name] + low battery".

SMS notification of tampering sensors

This feature applies to sensors with a built-in tamper switch. You will receive a message
and an alarm call when a sensor is sabotaged. The message exists out of the sensor
name supplemented with the message "Tamper alarm".

SMS notification of AC power failure and recovery

This failure applies to control panel when the main power was cut off. You will receive a
message with "Control panel AC failure. " When the main power recovers, it will notify
as "Control panel AC recovery. "
Arm & Disarm by free phone call
Arming the alarm system can be done by calling the SIM card telephone number in
the control panel. When you hear the dialing tone, hang up. You will be called back by
the same number. Do not answer but decline the call. The alarm will be armed.
Disarming the alarm system can be done by calling the SIM card telephone number.
Keep hanging until the system disconnects by itself. The alarm system will not call you
back and the alarm system is disarmed.
IMPORTANT: To arm or disarm the alarm system, make sure voicemail is
disabled on the SIM card of the alarm system.
Connect (new) wireless sensors, remote controls & RFID tags

Connect new wireless sensors and remote controls

The included sensors are paired with the control panel by default. If you want to pair
new sensors, follow these instructions: enter the password and press the
the control panel. Now you can pair a sensor by triggering it. For remote control, press
any button .When you hear a beep from the control panel, the sensor or remote
control is paired successfully. If you hear the control panel beep twice, it has already
been paired before.
35
X500-UM-EN-IT-ES-PT-V1.0.indd 42-43

Connect new RFID tags

Enter the password and press the button
Now you can hold a RFID tag in front of the RFID reader on the control panel. When
you hear a beep from the control panel, the RFID tag is paired successfully. If you hear
the control panel beep twice, the RFID tag has already been paired before.
IMPORTANT:
connected to AC. The LCD screen will show how many remote controls, sensors
and RFID tags are paired with the control panel. For example, if LCD screen
display as
tag have paired with the control panel.

Connect wireless siren

This siren is an extra accessory. Put the siren into connecting state. Then press the arm
button on the control panel. You will hear a single beep when paired successfully.
Please refer to the manual of siren on how to make it into connecting state for details.

Delete all accessories

To delete all accessories, hold the disarm button, then slide the power switch from off
to on (If the control panel is on, slide it to off first). 3 beeps will be heard within 10
seconds, then you can release the disarm button. All accessories (remote controls,
sensors and RFID tags) are deleted.

Delete wireless siren

Hold the connect button of the wireless siren until a beep is heard. It indicates the
connection between the wireless siren and the control panel is deleted.
button on
on the control panel. The button lights up.
The RFID tag does only function when the control panel is
. Which represents 1 remote control, 2 sensors and 1 RFID
EN
36
2016/12/9 9:27:54