Installing The Child Seat - Be Cool vulcano Manual De Instrucciones

EN Notice: This child restraint system has been
approved under Standard R129 to be used by
children height between 76-150cm Please do not
leave the child unattended inside the vehicle.
Please read the instructions carefully. Incorrect
installation of the child restraint system could
cause serious consequences for the child. In the
case of incorrect installation the manufacturer is
in no way responsible.

1. INSTALLING THE CHILD SEAT

INSTALLATION FROM 76 TO 105CM
Slide the ISOFIX connector arms B (
1. 1
maximum length by turning the ISOFIX connector
arms extension lever A (
Do this on both sides of the seat.
Extend the top tether and place (
30
IM 2210,00 VULCANO_ print.indd 30
5 ) to their
16 ).
4 ) on top of the
seat.
1. 2 Connect the ISOFIX connector arms until you
hear them click into place.
The ISOFIX connection indicator (
red to green. Push the seat as far back as possible.
Make sure that both ISOFIX are in the same position
once you have pushed the seat back.
1. 3 Connect the Top Tether in the anchor point in
the vehicle marked with the symbol.
The connector may be closed without being secured
in the ISOFIX anchor. Please make sure that the
connectors are correctly fastened into the anchor
points of the vehicle by pulling the seat once it has
been installed.
To detach the seat follow the same steps in reverse.
Move the button ( 15 ) to open the connector and
release the anchors.
17 ) will turn from
22/9/20 11:11