Yakima HoldUp Plus2 Manual De Instrucciones página 2

remove end cap
from holdup.
Using a flathead screwdriver, remove
the end cap from the holdUp.
Install maIn Bolt.
attach fIrst traY to Base.
Align holes in base to holes in tray.
• Insert bolt, lock-
washer, and washer,
in order shown.
• Tighten with supplied
wrench.
1033534A-2/18
Insert plus2 Base Into holdup.
Align
• Pull spring pin to
• Insert bolt, and
lock-washer in
• Lift frame.
order shown.
• Release spring pin. Pin
• Tighten with
adjustable
wrench.
rotate to uprIght posItIon.
release base.
should snap into place.
pivot arm
IMPORTANT: Wheel strap is
to your right, and pivot arm is
Insert the Plus2 base
into the holdUp tube,
aligning holes.
wheel strap
LowEr TrAY:
to your left.