Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Quick Start Guide
Model: DPPR100 SKU#: 1001 218 982
1. Remove the elbow insert from the pump
body.
2. Connect the plug to the elbow
insert hole.
3. Thread the pressure regulator into
discharge outlet. Screw the 1/4 in.
brass elbow into the 1/4 in. hole on the
side of the pressure regulator. Slide
the plastic tubing over the 1/4 in. brass
elbow connected with the pressure
switch connector.
NOTE: Reference the manual for more details.
4. Turn the regulator adjustment
screw down tight.
5. Turn on the pump. If the pump is
properly primed, a high pressure will
immediately show on the pressure
gauge.
6. With the pump operating at high
pressure, slowly unscrew the adjusting
screw until maximum water flow is
obtained without pressure dropping to
zero.
7. If pressure falls completely, retighten
the screw and readjust it.
8. If no pressure shows, stop the pump,
remove the pressure regulator from
pump, add more water, and try again.
9. After the adjusted bolt is set up, lock
the screw nut on the bolt.
10. The pump is ready for use.
Publicidad
Manuales relacionados para Everbilt DPPR100
Resumen de contenidos para Everbilt DPPR100
- Página 1 Quick Start Guide Model: DPPR100 SKU#: 1001 218 982 1. Remove the elbow insert from the pump 4. Turn the regulator adjustment body. screw down tight. 2. Connect the plug to the elbow 5. Turn on the pump. If the pump is insert hole.
- Página 2 Guía de Referencia Rápida Modelo: DPPR100 SKU#: 1001 218 982 1. Extracción de la inserción del codo del 4. Gire el tornillo de ajuste del cuerpo de la bomba. regulador apretadamente hacia abajo tubo de presión codo 2. Conexión de la clavija en el 5.