Publicidad
Idiomas disponibles
Idiomas disponibles
Attach snaparounds to REAR
crossbar (2 per roller)
facing in opposite directions
as shown.
Release brakes on rollers
by pulling and turning to
the left.
Tighten Straps
• Insert end of
plain strap into
buckle as shown.
• Tighten straps.
1032113F-2/9
BRAKE TABS MUST FACE
OUTBOARD.
15" / 38cm
NOTE: 15"(38cm) is an average
distance and will need to be adjusted
to your boat's hull.
Install a second
pair of Hully
Rollers, Mako or
LandShark Saddles
on FRONT crossbar.
SET ROLLER BRAKES:
Pull tab out and
to the right
while rocking
boat gently
until the brake
tabs nest.
Insert bolts from above, 2 per roller.
Position boat hull on rear rollers,
and slide boat onto vehicle.
Attach straps, holding the buckle end.
Pass a strap over the boat, and under
each crossbar.
NOTE:
Always pass the strap
inboard to the tower
You may need to loosen hex keys and
slide rollers inboard or outboard so that
rollers rest against the hull.
TEST MOVEMENT BY
Tie down boat at front
ROCKING BOAT.
and rear. Tighten straps
Tighten again if loose.
and hex keys.
Attach hex keys and
tighten COMPLETELY.
BEFORE
DRIVING
AWAY:
Publicidad
