Yakima HookUp Manual De Instrucciones página 2

PREPARE THE BASE
OF THE CARRIER.
• Install the base pin keeping
the holes aligned.
• Insert the clip into the end.
SECURE hitch bolt
with safety clip.
SECURE WITH HARDWARE.
ROTATE PIVOT ARM CLEAR OF SUPPORT TRAY.
To release hook,
press the trigger
on the handle.
1033306A-2/12
INSERT BASE INTO
HITCH RECEIVER.
The holes in the base
must align to the holes
in the hitch receiver.
ATTACH FIRST TRAY TO BASE.
Align holes in tray to holes in base.
FIRST TRAY:
Wheel strap is
to your right,
and pivot arm
faces you.
Insert bolt, washer, and
nut, in order shown.
Tighten with hex
wrench (included)
and 17 mm wrench.
Slide the hook down enough to
clear the rear wheel cradle.
ATTACH SECOND TRAY TO BASE.
• Attach second tray in opposite direction.
• Install tray with the pivot arm facing
towards you.
• Secure with hardware.
• Rotate pivot
arm to other
side of support
tray.
• Extend hook to
end of arm.
FASTEN HITCH BOLT.
• Insert hitch bolt and washer
from RIGHT TO LEFT.
• Tighten with 7/8" wrench.
wheel strap
pivot arm