Switching On/Off - Evolution S210CCS Manual Del Usuario

www.evolutionpowertools.com
WARNING: These machines must never be used to cut
Asbestos or any material that contains, or is suspected
to contain, Asbestos. Consult/inform the relevant authorities,
and seek additional guidance if Asbestos contamination is
suspected.

SWITCHING ON/OFF

This machine is equipped with a safety start trigger switch.
To start the machine:
• Push in the safety lock button, (3), on either side of the
handle with your thumb.
• Depress the main trigger switch, (15), to start the motor.
To stop the motor:
• Release the trigger switch.
WARNING: The motor should never be started with the
saw blade in direct contact with any surface of
the workpiece.
CHIP COLLECTOR
This machine is fitted with a detachable Chip Collector, (12) to
capture metal chips. It is provided with a transparent 'window' ,
(14), so that the operator can see the contents and empty.
Note: When chips reach the arrow, this is an indication that the
chip compartment is almost full.
To remove and empty the Chip Collector, depress the release
button and pull away from the machine, (13). Empty the
contents of the chip collector by sliding the door up, (Fig.14a),
and tipping the contents out over a suitable waste container
and disposing in an environmentally responsible manner.
To replace the chip collector, the clips on the collector,
(Fig.14b), must be inserted behind the hinges, prior to
pressing the collector into place.
WARNING: The Chip Collector is very efficient and must
be checked and emptied at regular intervals. When
cutting steel the Chip Collector can become hot and care must
be taken when handling.
(b)
Fig. 14
15
(a)
EN