Step 6
Figure 1 shows valve stem and bezel with
the control knob removed. Take five large
stop plates from the component card and
place them over the valve stems as
illustrated (Figure 2). Verify the tab and
the stamped letter on the stop plates face
out. Replace control knobs when finished.
WARNING: We recommend and request
that you do not remove the control panel
in order to access the valve tips. If you
choose to remove the control panel, you
must replace the control panel bezels
exactly as illustrated in Figure 2. Failure to
replace the bezels as illustrated could
lead to personal injury and/or property
damage.
Step 7
Carefully replace each burner, making
sure burner openings slide over valve
nozzles. Screw each main burner "foot"
down using screwdriver and screws that
were set aside in Step 3.
Step 8
Replace warming rack, cooking grills, heat
shields and grease tray.
7
Tab
Figure 1
Stop Plate
Stop Pin
Figure 2
Warming Rack
Cooking Grills
Heat Shields