Periodic Maintenance - Nordcap Moretti Forni iR 260 - iLab Manual Instrucciones

7. Close the fastening thrusts (x2)
. Check the two fastening thrusts are correctly coupled.
If not, they can cause serious damage to the machine.

10.2 PERIODIC MAINTENANCE

To ensure the machine works properly and, in particular to ensure a long life, you are advised
to periodically clean the ring on the head (see instructions below).
The stainless steel parts, the painted covers, the polyethylene PE500 and the plates in PETG
can be easily cleaned with water and soap or a neutral detergent, then you need to rinse them
with plenty of water and dry them with a soft cloth.
Having removed the upper casing as previously described, continue as illustrated
1. Open the cutting unit
accompanying it
support. Remove the
ring fastenings (x2)
2. Remove the ring and
to the clean it inside with a plastic
scraper.
8. Place the upper casing by screwing in the
specific fastenings (x2)
UK/15
3. Close the cutting unit
accompanying it
support and close
fastening thrusts (x2)
to the
the