Installing The Belt Clip - Qwest 2.4GHz Multi-Handset Cordless Phone System Manual Del Usuario

2.4GHz Multi-Handset Cordless Phone System
1. Plug the AC power supply into a standard 120 VAC wall outlet.
2. Locate the larger of the two connectors (RJ 45) and plug it into the back of the
base.
3. The Power light on the base will illuminate.
4. Plug the smaller of the two connectors (RJ 11) into your telephone jack in the
wall.

Installing the Belt Clip

Installing the belt clip enables you to transport the handset on your belt.
1. Remove the belt clip from the handset accessory kit. Place the belt clip at the top
of the back of the handset.
2. Slide the belt clip into place as illustrated.
3. Snap the pins on the inside of the belt clip's arms into the pin holes near the
handset's ear piece.
Page 10