2.4GHz Multi-Handset Cordless Phone System
FCC Wants You to Know
Federal Communications Commission Requirements
This telephone system complies with Part 68 of the FCC rules. On the bottom of the base station
is a label that contains, among other information, the FCC Registration Number, Ringer
Equivalence number (REN) and the Universal Service Order Code (USOC), which is RJ-45, for this
equipment. You must, upon request, provide this information to your telephone company. The
REN is useful to determine the quantity of devices you may connect to your telephone line and
still allow all of those devices to ring when your telephone number is called. In most, but not all
areas, the sum of the RENs of all devices connected to one line should not exceed five (5.0). To
be certain of the number of devices you may connect to your line, as determined by the REN, you
should contact your local telephone company. If your telephone equipment causes harm to the
telephone network, the telephone company may ask you to disconnect the system from the line
until the problem has been corrected or they may discontinue your service temporarily. If
possible, they will notify you in advance.
Your telephone company may make changes in its facilities, equipment, operations, or
procedures that could affect the proper functioning of your telephone system. If they do, if
possible you will be notified in advance to give you an opportunity to maintain uninterrupted
telephone service. If you experience trouble with this telephone system, disconnect it from the
network until the problem has been corrected or until you are sure that the equipment is not
malfunctioning. Do not attempt to repair or modify this equipment. Changes or modifications not
expressly approved by the party responsible for its compliance could void the user's authority to
operate the equipment. This telephone system may not be used on coin service provided by the
telephone company. Connection to party lines is subject to state tariffs. If trouble is experienced,
disconnect this equipment from the telephone line to determine if it is causing this malfunction.
If the equipment is determined to be malfunctioning, its use should be discontinued until the
problem has been corrected. Current FCC regulations specify that any direct connections to a
telephone company line be done using only standard phone jacks and plugs that meet FCC
regulations. Privacy of communications may not be ensured when using this phone.
This telephone system equipment has been tested and found to comply with the limits for Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This device
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1)
This device may not cause harmful interference, and 2) This device must accept any interference
received, including interference that may cause undesired operation. Some cordless telephones
operate at frequencies that may cause interference to nearby TVs and VCRs; to minimize or
prevent such interference, the system base should not be placed near or on top of a TV, PC
monitor, or VCR; and, if interference is experienced, moving the desk station farther away from
the TV or VCR will often reduce or eliminate the interference. However, there is no guarantee that
interference will not occur in a particular installation. If this telephone system does cause harmful
interference to radio or television reception, which can be determined by turning the system off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•
Increase the separation between the base station and receiver.
•
Connect the base station to an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio TV technician for help.
NOTICE TO HEARING AID WEARERS: This phone system is compatible with inductively coupled
hearing aids.
Page 36