Care And Maintenance; Switching The Appliance Off; Cleaning The Appliance; Cleaning The Oven Door - Sholtes BC 99DT P XA Manual De Instrucciones

Care and maintenance

Switching the appliance off

GB
Disconnect your appliance from the electricity
supply before carrying out any work on it.

Cleaning the appliance

• The stainless steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for
the removal of stubborn stains. After cleaning,
rinse and dry thoroughly. Do not use abrasive
powders or corrosive substances.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• The accessories can be washed like everyday
crockery, and are even dishwasher safe.
! Never use steam cleaners or pressure cleaners on
the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack.
For more thorough cleaning purposes, the oven door
may be removed:
1. Open the oven door fully ( see diagram ).
2. Use a screwdriver to lift up and turn the small
levers F F F F F located on the two hinges ( see diagram ).
30
F
3. Grip the door on the two
outer sides and close it
approximately half way. Pull
the door towards you, lifting it
out of its seat ( see diagram ).
To replace the door, reverse
this sequence.
Inspecting the seals
Check the door seals around the oven at regular
intervals. If the seals are damaged, please contact
your nearest Service Centre ( see Assistance ). We
recommend that the oven is not used until the seals
have been replaced.

Replacing the light bulb

To replace the oven light bulb:
Lamp Holder
compartment
Lamp
Glass cover
3. Replace the glass cover ( see diagram ).
! Do not touch the light bulb directly with your
hands.

Assistance

Warning:
The appliance is fitted with an automatic diagnostic
system which detects any malfunctions.
Malfunctions are signalled through messages of the
following type: "F F F F F ", followed by numbers.
Call for technical assistance in the event of a
malfunction.
! Never use the services of an unauthorised
technician.
Please have the following information to hand:
• the type of problem encountered;
• the appliance model (Mod.);
• the serial number (S/N).
The latter two pieces of information can be found on
the data plate located on the appliance.
1. Remove the
glass cover of the
lamp-holder.
2. Remove the
light bulb and
replace it with a
similar one:
halogen lamp
voltage 230 V,
wattage 25 W,
cap G 9.