Installation - NAMCO PANIC PARK Manual Del Operador

4. INSTALLATION

Notes on Installation
WARNING
WARNING
WARNING
CAUTION
NOTE
1. Outdoors
2. Direct Sunlight, places with excessive humidity or dust, places where
there is water leakage, near air-conditioning or heating equipment, places
with excessive heat or cold temperature.
3. Places where it would be in the way of emergency exits or fire
extinguishing equipment.
4. Unstable places or places with excessive vibration.
5. Places that are not level.
6. This machine must not be cleaned with a water jet, or installed in an area
where a water jet could be used.
• N E V E R t u r n t h e p o w e r t o t h e m a c h i n e O N u n t i l
installation has been completed.
• In order to prevent possible electric shocks, be sure
that the machine is connected to the mains with a
securely connected earthed plug.
• So that customers are not injured , ensure that there is
at least 500mm separation between other machines or
walls.
• In order to avoid damage to the machine due to mis-
operation, ensure that the voltage of the mains supply is
230volts AC.
• If the location site of this machine has a polished floor it is
recommended that rubber pads are fitted under the level
adjusters to prevent the machine sliding on the floor.
• In order to gain access to the Power Supply and CPU
assemblies, make sure that the rear of the machine is
separated from a wall or other machine by at least 500mm.
• When installation is complete, it is imperative that the game
is initialized.
This machine is designed for INDOOR USE ONLY.
Do not install in the following places.
(See section 7 page 50)
Page 32