I/O Test - NAMCO PANIC PARK Manual Del Operador

6-3-3 I/O Test

1. Select "I/O TEST" on the menu screen to test the switches and lamps.
The following screen is displayed.
2. Use the Select Up/Down switch to choose the required item then press
the Enter button to enter the test.
3. Select "EXIT" and press the Enter button to return to the menu screen.
DIP 4
I/O PCB CHECK
I/F INITIALIZE
SWITCH TEST
LAMP TEST
EXIT
(a) Shows the condition of the DIP Switches on the PCB. In normal operation
all switches are OFF. (If a switch is ON, it will be displayed in red.)
(b) Checks function of I/O PCB.
(c) Initialize lever potentiometers.
(e) Selecting this item allows all switches to be checked.
(See 6-3-3-3 page 46)
(f) Selecting this item allows the testing of the start button lamps.
(See 6-3-3-4 page 47)
I/O TEST
12345678 [ON:RED]
SELECT SW : CHOOSE
ENTER SW : ENTER
Page 44
.............................................. (a)
............................................
............................................
............................................
............................................
(see Section 7 page 50)
(b)
(c)
(d)
(e)