Briggs & Stratton Snapper LT75 Serie Manual Del Operador página 36

Troubleshooting Chart
Problem
The unit will not move when the brake is
released and the speed control pedal is
depressed.
The unit moves slower or stops when the
clutch is engaged.
The unit moves slower or stops when the
speed control pedal is depressed.
When the clutch/brake pedal is released, belt
noise can be heard.
The rear wheels spin over uneven terrain.
The transaxle is difficult to shift between
gears with the engine running and the clutch
depressed.
36
1. Check the motion drive belt. Make sure the belt is installed correctly.
2. Adjust the clutch.
3. Replace the motion drive belt.
4. Release the Automatic Drive Disconnect under the seat.
1. Adjust the clutch.
2. Replace the motion drive belt.
1. Adjust the clutch.
2. Replace the motion drive belt.
1. Temporary belt noise does not change the operation of the unit. If
belt noise is continuous, check the routing of the belt. Make sure the
belt is inside all belt guides.
2. If the noise is continuous, adjust the clutch.
1. Check the front axle. If the front axle does not freely pivot, loosen the
axle bolt(s).
1. Check the clutch adjustment to make sure the belt stops when the
clutch pedal is depressed with the transaxle in (N) neutral.
2. Check the belt guides around the transaxle drive pulley. Make sure
the belt guides do not touch the pulley.
Solution
en