ESYLUX PD-C360i/24 DIMplus-FM Manual De Instrucciones página 17

Button Customised setting
Selecting the channel
Selects the appropriate channels.
Switch ON/OFF manually
Switches ON/OFF the lighting of the previously
selected channel C1 + C2.
Changing the DIM value
Modifes the DIM light value of the previously selected
channel C1 – C2.
1. Select the channel you want to dim (C1 or C2).
2. Start the dimming process by pressing the DIM button.
3. Freeze the DIM value by pressing the EYE button.
End the "test"/manual light ON/OFF/time setting function
Return to preset mode
Channels 1 – 2 remain permanently switched on during test mode.
Each time a movement is detected, the blue mode
LED flashes twice, regardless of the ambient lighting
level. Press the "Reset" button to exit.
Programming
The following functions can only be programmed when the device is
in programming mode. All changes are stored and the functions are
implemented after exiting programming mode.
Enter programming mode
Blue LED lights up to indicate programming mode.
Light channel C1 is switched on with 100 % luminous
efficiency. The detector's movement sensor is
disabled whilst the device is in programming mode.
Exit programming mode
Blue LED goes out; the settings are now stored.
The detector will now operate automatically
according to the preset values.
NOTE: If programming mode is not exited by
pressing the button, the detector automatically
exits programming mode 10 minutes after the last
button was pressed. All functions set up until this
point will be stored.
Selecting the channel to be programmed
Acknowledgement:
C1 = red and blue LEDs flash
C2 = green and blue LEDs flash
GB
17