ESYLUX PD-C360i/24 DIMplus-FM Manual De Instrucciones página 18

When the "DIM" button is pressed once, the dimmer
automatically starts to slowly adjust the light intensity of the
lighting from the maximum to the minimum value. When the
required ambient brightness level has been reached, press
the "Eye" button. The new brightness set value is then stored.
GB
Setting the brightness set value (100 lux – 750 lux)
Acknowledgement: red and blue LEDs flash three times,
light is automatically adjusted to the set value.
Daytime operation setting (2,000 lux)
Acknowledgement: red and blue LEDs flash three times
(channel 1), no light measurement, light is only
activated by presence.
Time setting for C1 + C2 (HVAC) = identical!
If no movement is detected, the time setting starts.
Fade-out time for orientation light
Once the orientation light value has been set, set the
time for the afterglow feature.
Orientation light "OFF"
18
Switch between fully automatic and semi-automatic mode for
light channel C1
For semi-automatic mode, the blue LED turns off for
approximately 2 seconds.
For fully automatic mode, the blue LED flashes 3 times.
Switch between fully automatic and semi-automatic mode for
HVAC channel C2
For semi-automatic mode, the blue LED turns off for
approximately 2 seconds.
For fully automatic mode, the blue LED flashes 3 times.
ECO semi-automatic mode for light channel C1
Press the "C1" button, followed by "A/M" (regardless of
the original status). The "100 Lux" button must then be
pressed within 2 seconds. The green LED will flash once.
Corridor semi-automatic mode for light channel C1
Press the "C1" button, followed by "A/M" (regardless of
the original status). The "200 Lux" button must then be
pressed within 2 seconds. The red LED will flash once.
Switch LEDs ON/OFF (red/green LED)
To switch LEDs off = press button, the blue LED will
turn off for approximately 2 seconds.
To switch LEDs on = press button, the blue LED will
flash 3 times.
Restore factory settings
Confirmed by brief alternate flashing of the blue and
red LEDs on the detector.