Blackstar Amplification Live Logic Manual Del Usuario página 51

 CC –控制更改
 MIDI CHANNEL - Set the MIDI Channel on which the selected footswitch/
expression pedal sends the Program Change message.
 CC MESSAGE NUMBER - Set the Control Change (CC) number that you wish to
trigger when pressing the selected footswitch or expression pedal. Refer to the
MIDI table in the user manual of the device(s) you wish to control to determine the
function of each CC message. By default, in Custom Mode, the 6 footswitches are
set to CC0 - CC5.
 OPERATION – This determines the operation of the 6 footswitches:
• Momentary - Sends the 'On' value when the footswitch is pressed and the 'Off'
Value when the footswitch is released. The corresponding LED will be lit whilst
the footswitch is pressed.
• Toggle - Sends the 'On' value when pressed once and will stay on until pressed
again. The corresponding LED above the switch will be lit whilst toggled on.
 OFF VALUE - Select the data value to send when in the off position. This should
usually be set to 0 for normal use.
 ON VALUE - Select what value to be sent when in the off/minimum position. This
should usually be set to 127 for normal use.
 EXAMPLE If you want you to use a one button Gain Boost, set the CC number to
control Gain on your Amp/ Plugin, Set the off value to your normal gain level and
the on value to your boosted gain, then set the 'Operation' to toggle. This switch
can now be used like a boost pedal.
100
音符
 MIDI CHANNEL-设置MIDI通道，选定的脚踏开关/表情踏板在其上发送程序变
更信息。
 OPERATION–确定6个脚踏开关的操作：
• Momentary-按下脚踏开关时发送" On"值，释放脚踏开关时发送" Off"值。
踩下脚踏开关时，相应的LED将点亮。
• Toggle-按下一次时发送"开"值，并且保持开启状态直到再次按下。 接通
时，开关上方的相应LED指示灯将点亮。
 Note-选择要发送的音符。
 Octave-选择发送当前选择的音符的哪个"八度"。
 OFF VALUE-选择处于OFF位置时要发送的数据值。 正常使用时通常应将其设
置为0。
 ON VALUE-选择在关闭/最小位置时要发送的值。 正常使用时通常应将其设置
为127。
101