Midi Channel - Blackstar Amplification Live Logic Manual Del Usuario

 CC - CONTROL CHANGE
 MIDI CHANNEL - Set the MIDI Channel on which the selected footswitch/
expression pedal sends the Program Change message.
 CC MESSAGE NUMBER - Set the Control Change (CC) number that you wish
to trigger when pressing the selected footswitch or expression pedal. Refer to the
MIDI table in the user manual of the device(s) you wish to control to determine the
function of each CC message. By default, in Custom Mode, the 6 footswitches are
set to CC0 - CC5.
 OPERATION - This determines the operation of the 6 footswitches:
• Momentary - Sends the 'On' value when the footswitch is pressed and the 'Off'
Value when the footswitch is released. The corresponding LED will be lit whilst
the footswitch is pressed.
• Toggle - Sends the 'On' value when pressed once and will stay on until pressed
again. The corresponding LED above the switch will be lit whilst toggled on.
 OFF VALUE - Select the data value to send when in the off position. This should
usually be set to 0 for normal use.
 ON VALUE - Select what value to be sent when in the off/minimum position. This
should usually be set to 127 for normal use.
 EXAMPLE If you want you to use a one button Gain Boost, set the CC number
to control Gain on your Amp/ Plugin, Set the off value to your normal gain level and
the on value to your boosted gain, then set the 'Operation' to toggle. This switch
can now be used like a boost pedal.
16
NOTE
 MIDI CHANNEL - Set the MIDI Channel on which the selected footswitch/
expression pedal sends the Program Change message.
 OPERATION - This determines the operation of the 6 footswitches:
• Momentary - Sends the 'On' value when the footswitch is pressed and the 'Off'
Value when the footswitch is released. The corresponding LED will be lit whilst
the footswitch is pressed.
• Toggle - Sends the 'On' value when pressed once and will stay on until pressed
again. The corresponding LED above the switch will be lit whilst toggled on.
 NOTE - Select which Note to send.
 OCTAVE - Select which 'Octave' to send the currently selected Note.
 OFF VALUE - Select the data value to send when in the off position. This should
usually be set to 0 for normal use.
 ON VALUE - Select what value to be sent when in the off/minimum position. This
should usually be set to 127 for normal use.
17