Orbea BLUE PAPER VIBE 2021 Manual Del Usuario página 34

66 | ORBEA
EBIKE MOTIO N C O MP ON E N TS
REMOVAL/ASSEMBLY INFORMATION
Read the X35 system Use Warnings section
of this manual to know the correct installa-
tion instructions for the rear wheel, cables,
PASS sensor and rear rotor.
Always follow the recommended torque
settings for all the components on your
bicycle.
The removal and installation of the X35
system components may require to remove
and install several mayor components of
the bicycle, such as the fork, the chainset
and bottom bracket, and may therefore
be beyond the mechanical knowledge of
most users. Always take your bicycle to an
authorized Orbea dealer for the installation
and replacement of these components.
The incorrect installation of the bicycle
components may be cause of accidents and
serious injuries, as well as cause damage to
the components that may not be covered
by the warranty.
Always take the necessary precautions
when working with electric components to
avoid electric shocks and damage to the
components. Connect all components in
the correct way to avoid short circuits and
exposure to elements. Cover any crimped
cable connections (if there were any) with
heat shrink tubing or electrical tape to avoid
short circuits.
TECHNICAL MANUAL
REPLACING THE IWOC TRIO AND THE LIGHTS CABLE
To replace the Iwoc Trio it is necessary to remove the
fork from the bicycle to access all components and con-
nections through the bicycle headtube (it is not necessary
to disconnect the brake lines).
If you do not have the necessary mechanical skills, always
take your bicycle to an authorized Orbea dealer for the
installations and replacement of the pedelec system com-
ponents.
The installation and replacement of the lights cable
requires the removal of the internal battery and must be
performed by an Authorized Orbea dealer. Read the Lights
section of this manual to know about the lights cable
routing on Vibe.
REPLACING THE X35 INTERNAL BATTERY
Replacing the X35 internal battery is a process that
requires advanced mechanical knowledge for its correct
installation.
BLUE PAPER VIBE · 2021
The bicycle fork, chainset and bottom bracket need to
be removed and all the pedelec system components
disconnected.
Replacing the X35 internal battery is a process that must
be performed by an authorized Orbea dealer.
The X35 internal battery on your Orbea bicycle carries all
the relevant information about your bike, such as the serial
If the internal battery needs to be replaced due to natural
wear or a warranty claim, contact your authorized Orbea
dealer, who will provide Orbea with your bicycle informa-
tion and carry out the claim and installation.
The X35 internal battery is installed inside the
Vibe downtube vertically. For that purpose,
internal batteries from MY2021 and onwards
feature two threaded holes on their side for
installation on 2021 Gain and Vibe frames,
besides the three holes on its bottom side
for installation on pre2021 Gain frames.
Batteries from MY2021 are compatible with
pre2021 Gain, Optima and eMX24 frames.
However, pre2021 batteries are not compati-
ble with MY2021 and onwards frames.
ORBEA | 67
Pre MY2021
Pre MY2021
REPLACING THE PASS SENSOR
The PASS sensor can be replaced without removing
any other component from the bicycle (besides the
rear wheel).
Remove the rear wheel from the frame. Remove the bo-
ttom bracket cover from the frame and locate the PASS
sensor cable connector to the battery cable. Disconnect
the PASS sensor cable.
Loosen the PASS sensor grubscrew on the right dropout,
carefully pull from the PASS sensor cable from the rear
dropout until the PASS sensor cable is completely out of
the right chainstay.
Follow the opposite process to install a new PASS sensor.
Make sure that the distance between the PASS sensor
once it is installed in its housing and the magnetized cas-
sette lockring is 3mm maximum.
Install the BB cover and install the rear wheel on the frame
making all connections and following the recommended
torque settings as shown in this manual.
EN