Cleaning And Servicing; Spare And Wearing Parts - Bosch WBE 4120 Instructions De Réparation

en 68 | WBE 4120 / WBE 4120 D / WBE 4120 DT | Replacement interventions
!
When it is necessary to replace the board, activate
the board and perform the various calibration pas-
sages.
11.8 Substitution of the board
NOTES FOR THE ASSISTANCE
When you need to substitute the board (code 654044),
remember to set up the correct configurations (chapter
5 and chapter 6) and complete the calibration proce-
dure (chapter 7).
1. Power supply
2. Encoder
3. Pick-up int
4. Pick-up ext
5. Calibers
6. F=400mAT
7. F1=500mAT
8. Buzer (Bip)
!
NOTE: The sensors (code 654432) are identical. In
order to distinguish them during the production,
they mount the red pick-up outside and the black
one inside (chapter 8.4.1).
|
1 695 600 579 2016-08-02
12. Maintenance
12.1

Cleaning and servicing

!
Before cleaning and servicing, switch off
WBE 4120 / WBE 4120 D / WBE 4120 DT and dis-
connect mains plug.
!
Do not use any solvent-based cleaning agents. Use
alcohol or similar cleaning agents for plastic parts.
The following work is essential to ensure pro-
per operation and high performance of the
WBE 4120 / WBE 4120 D / WBE 4120 DT:
12.2

Spare and wearing parts

The manufacturer cannot accept any liability for
damage arising from the use of non-genuine replace-
ment parts.
Designation
Standard centering flange
Centering cone 42 - 65 mm
Centering cone 54 - 80 mm
Centering cone 75 - 110 mm
Weight pliers
Manual vernier caliper
Test clip
Calibration weight
Calibration weight (calibrated)
Voltage sticker V 230
Voltage sticker V 110
Direction of wheel rotation sticker
Tab. 2: Spare and wearing parts
Bosch Automotive Service Solutions GmbH
Order number
1 695 602 400
1 695 632 500
1 695 652 862
1 695 605 600
1 695 606 500
1 695 629 400
1 695 602 700
1 695 654 377
1 695 654 376
1 695 101 269
1 695 100 854
1 695 653 878