Preparing The Machine; Installing The Rops Pivot Shoulder Bolts - Toro Z Master 4000 Manual Del Operador

1

Preparing the Machine

No Parts Required
Procedure
1. Park the machine on a level surface.
2. Move the motion-control levers to the N
3. Engage the parking brake.
4. Shut off the engine and remove the key.
2
Installing the ROPS Pivot
Shoulder Bolts
Parts needed for this procedure:
2 Shoulder bolt
2 Wave washer
2 Locknut (1/2 inch)
Procedure
1. Secure the shoulder bolt to the roll bar using a
wave washer and locknut (1/2 inch) as shown
in Figure 5.
2. Repeat this procedure on the other side.
-L position.
EUTRAL OCK
Figure 4
1. Locknut (1/2 inch)
2. Wave washer
9
Figure 5
3. Shoulder bolt
g037289
g341473