Adjusting The Parking Brake; Checking The Tire Pressure - Toro Z Master 4000 Manual Del Operador

11. Join the upper and lower tubes with 3 bolts (#10
x 3/4 inch), flat washers, and locknuts as shown
in Figure 37.
Figure 37
1. Lower tube
2. Upper tube
3. Flat washer (7/32 inch)
12. Install the lower tube onto the blower housing
and secure it with the latches.
15
Adjusting the Parking
Brake
No Parts Required
Procedure
Check to ensure that the parking brake is adjusted
properly. Refer to your Operator's Manual for the
correct procedure.
g003392
4. Locknut (#10)
5. Bolt (#10 x 3/4 inch)
16

Checking the Tire Pressure

For Machines with Pneumatic
Tires Only
No Parts Required
Procedure
Increase the tire pressure due to the additional weight.
Note:
This is not applicable with semi-pneumatic
tires.
Maintain the air pressure in the rear tires at 90 kPa
(13 psi). Uneven tire pressure can cause uneven cut.
Check the tires when they are cold to get the most
accurate pressure reading.
24
Figure 38
g001055