Installing The Blower Assembly - Toro Z Master 4000 Manual Del Operador

12
Installing the Blower
Assembly
Parts needed for this procedure:
1 Blower assembly
1 Pivot pin
1 Roll pin
Procedure
Verify that the pivot pin is secured on the blower
assembly in the correct location
26).
•
If you have a 48-inch or 52-inch mower deck,
there is only a single hole to install the pivot pin
(Figure 25).
Figure 25
1. Blower assembly
2. Roll pin
•
If you have a 60-inch mower deck, install the pivot
pin in the rear hole
(Figure 25 or
3. Pivot pin
(Figure 26).
Figure
1. Blower assembly
2. Rear hole
1. Align the pivot pin on the blower with the
pivot-pin hole in the mower deck
1. Blower assembly
2. Deck
g341588 2. Lower the blower and slide the pivot pin into the
pivot hole
Note:
in the blower pulley.
19
Figure 26
3. Roll pin
4. Pivot pin
Figure 27
3. Pivot hole
4. Blower-pivot pin
(Figure 27).
Ensure that the belt remains positioned
g341589
(Figure 27).
g038256