Confirm Proper Operation - Kohler K-1332 Guia De Instalacion

Use the arrow keys to adjust
the water flow volume
Press the
"Neck/Back/Dual"
button to control
the neck and
back jet functions

12. Confirm Proper Operation

Fill the Whirlpool
NOTE: Please read these steps carefully before you operate your whirlpool.
- Position the jet nozzles so they face down toward the basin. Turn the jet trim rings fully counterclockwise.
- Fill the whirlpool to a level to cover the water level sensors located either near one of the grip rails or the back
jets. The whirlpool will not operate unless these sensors are completely covered with water.
NOTE: The water temperature in the whirlpool should not exceed 104_F (40_C).
Operating Sequence
NOTE: A built in heater automatically maintains the water temperature when the whirlpool is running.
- Press the On/Off" button to turn on the whirlpool. The whirlpool will start at high volume.
- Increase or decrease the water flow by pressing either the up or down arrow keys on the On/Off" switch.
- Adjust each jet for optimum air/water mixture. Turn the trim ring clockwise to reduce the air flow, and
counterclockwise to increase the air flow.
- Press the On/Off" button a second time to turn off the whirlpool.
NOTE: A built in timer automatically stops the whirlpool after approximately 20 minutes of operation.
Neck and Back Jet Operation
- Make sure the slip cover is in place on the pillow, and the pillow is attached to the neck jet body.
- With the whirlpool running, press the Neck/Back/Dual" button to turn on the neck jets. The neck jet pulsing
action will start at medium speed.
- Increase or decrease the neck jet pulsing action by pressing either the up or down arrow keys on the
Neck/Back/Dual" switch.
- Increase or decrease the water flow by pressing either the up or down arrow keys on the On/Off" switch.
- Press the Neck/Back/Dual" button a second time to turn on the back jets and turn off the neck jets. Depending
upon the whirlpool model, either some, all, or none of the whirlpool jets will continue to run.
- Press the Neck/Back/Dual" button a third time to run the back jets and neck jets together. Depending upon the
whirlpool model, either some, all, or none of the whirlpool jets will continue to run.
- Press the On/Off" button at any time to turn off all the whirlpool functions.
NOTE: Park" the back jets to obtain a gentle, yet concentrated hydro massage. Press the down arrow key on the
Neck/Back/Dual" switch repeatedly until the pulse action stops and water flows continuously from only two
back jets.
NOTE: While in the Dual" mode, the neck jet pulsing action can be adjusted to its minimum speed with the back
jets parked."
NOTE: While sequencing through the whirlpool functions, both the neck and back jets will begin to run at the
speed they were last adjusted to.
B
1012425-2-
Press the "On/Off"
button to control the
whirlpool functions
Use the arrow keys to adjust the
neck and back jet pulsing action
Turn the jet trim
ring clockwise to
decrease the flow
10
Turn the jet trim ring
counterclockwise to
increase the flow
Kohler Co.