Unpacking And Assembly - Truper SINA-10 Instructivo

20
19
23

Unpacking and assembly

Due to tight quality controls there is a small probability that the tool has defects or missing parts. If there is any problem,
before using the tool and to prevent severe injury, please go to a
• Remove all loose parts from the packaging before
unpacking the tool.
• Remove the packing material around the tool.
• Carefully lift the saw grasping only by the carrying handle
(5). Sit the unit onto a totally leveled surface.
• Always carry the tool with the cutter head set down and
blocked with the release knob (2). Lift the saw only using
the carrying handle and / or the extension arms (22).
Prevent back injury. Seek help to lift the saw.
5
Parts
13
1
14
15
18
16
17
22
2
21
2
14
15
29
Mounting onto a work bench
• Find four orifices in each one of the four supports to fix the
base onto a worktable.
• Fix the base onto a perfectly leveled worktable. Use
screws (not included).
• Or, fix the base onto 1/2" or larger piece of plywood to
be able to fasten the board to the table or to carry it to
different work places.
WARNING
tilted or irregular surface will cause uneven cuts.
Cutter head release
• Once the tool is assembled, use the release knob (2) to
free the cutter head and use the saw.
• Press down the cutter head while pulling out the release
knob. Turn it 45° and release.
• Then, slowly lift the cutter head.
• To lock the cutter head back set it down while pulling out
the release knob. Turn it -45° and release.
4 3
6
11
31
14
17 28
Authorized Service Center
• Assembling the tool onto a warped,
ENGLISH
1
23
7