Cequent Performance Products 76143 Instrucciones De Instalación página 6

3d. Remove fascia – Using a T25 torx bit, remove (1) screw located
vertically in the upper area fascia behind the wheel well liner, both sides.
3f. Open the rear liftgate. Remove the (2) plastic liftgate bump stops.
© 2017 Cequent™ Performance Products, Inc. -
Printed in Mexico
3e. Remove fascia – Using a plastic trim panel tool, remove the lower part
of wheel well trim by unclipping the tabs from fascia and gently pulling
on trim.
3g. Remove fascia – Using a plastic trim panel tool, lift the molding near
bump stop, and using a 10mm socket, remove (1) screw per side holding
the fascia.
Sheet 6 of 24 76143NP 4-4-17 Rev. A