En - English - Integra Miltex Instrucciones De Funcionamiento

EN – ENGLISH
Miltex
Indications: The LED Loupes Light Source is intended for use ONLY in conjunction with
magnification loupes and should not be used without them. The light source is used to
illuminate the magnified field only.
Contents:
1. LED headlight and cable with loupes mount
2. Power pack with one lithium-ion rechargeable battery
3. Battery charger unit and AC power adapter
4. Curing filter
Cleaning Instructions
Proper cleaning and maintenance is imperative as well as protection from rough use and improper
storage. Disinfection with a low-alcohol (<25%) solution such as CaviCide
recommended. If using spray disinfectant, avoid spraying liquid directly on the unit. Instead, spray
onto a soft no-scratch cloth, and wipe the product as per disinfectant's directions for use.
Clean all lens surfaces only with optical cleaning cloth provided with the unit.
CAUTION
• DO NOT SUBMERGE PRODUCT OR SUBJECT TO SURFACE SATURATION WITH ANY LIQUID
OR ULTRASONIC CLEANER. Your product is not waterproof.
• DO NOT USE WITH ANY POWER ADAPTER, CHARGER UNIT, OR BATTERY OTHER THAN
PROVIDED BY PERIOPTIX.
• DO NOT CLEAN VIA AUTOCLAVE, CHEMICLAVE, GLUTARALDEHYDE, IODOPHOR, OR ANY
OTHER STERILIZATION METHOD.
• NO MODIFICATION OF THIS EQUIPMENT IS ALLOWED.
• THIS UNIT CONTAINS A LITHIUM-ION BATTERY. AS A RESULT, PLEASE BE SURE TO NOT
STORE THE UNIT UNCHARGED FOR AN EXTENDED PERIOD OF TIME, AS THIS MAY CAUSE
THE BATTERY TO DISCHARGE AND REDUCE THE LIFETIME OF THE UNIT.
Operating Instructions
1. Charging batteries.
a. Plug the power adapter (1) into a power outlet and connect to battery charger unit (2). A single green
light will indicate power to the charger.
b. Slide the battery from the power pack (3) into the charger unit (2) with connectors facing the pins.
Make sure the battery is lying flat on the charger base prior to sliding it forward to engage charger
terminals. Note: Pushing the battery forward without keeping it flat may damage charger pins.
c. When the battery is inserted into the charger, the charger status light turns from green to red to
indicate that charging has begun.
d. Once the battery is fully charged, the light will return to green.
2. Mounting the Light onto Loupes.
Attach the lamphead to loupes using the supplied mount and hardware. Slide clip onto front of
interpupillary cross bar of loupes, with one circular cut-out on top and one cut-out on the bottom of the
cross bar. The clip should securely snap into place.
2
Portable LED Loupes Light Source
®
Directions for Use
or CaviWipes is
® ®