Installation Instructions - Festo CPX-4AE-P Manual Del Usuario

3

Installation instructions

Warning
If the pneumatic tubing is under pressure when
dismantled, it may perform sudden unexpected
movements, causing injury to persons. Carry out the
following steps before disconnecting the pneumatic
tubing on the pressure sensor module:
Switch off the compressed air supply.
S
Make sure that all pneumatic tubing is pressureless.
S
Exhaust all actuators controlled by valves that are
S
blocked in the rest or middle positions.
3.1 Installing the pneumatic tubing
Connecting:
1. Cut off the end of the hose straight. Use a suitable
2. Press the hose into the QS connector as far as the
3. Group the tubing together with tube ties or a tube
Festo CPX−4AE−P 0906NH English
hose cutter for this.
stop (see picture).
holder for a better overview of the system.
11