Check Weighing - Adam Cruiser CKT Serie Manual Del Usuario

3.6

CHECK WEIGHING

Check-weighing is a procedure to display an indicator or sound an alarm when the weight on
the platform meets or exceeds the values stored in the memory. The memory holds values for
a high limit and a low limit. Either or both the limits can be set by the user.
Checkweighing Display
The LCD display will indicate whenever the weight is within or exceeds the limits by showing
"OK" (mass is between the limits), "HI"(mass is above the high limit) or "LO"( mass is below the
low limit).
Steps:
In normal weighing, Press the [Low Limit] key. It will show the current low limit. The
1)
"LO" symbol will appear on the display.
Press the [CE] key to clear the old value and then enter the new low limit using the
2)
numeric keys. Then press [Tare] ↵ to accept the value. If you want to reset the value
to zero, press [CE] to clear the value. The limits are displayed in the weighing unit in
use. If the weighing unit is pounds: ounces, the limits are entered in pounds and
decimal parts of pounds. i.e. 60.125 lb.
To set the high limit press [High Limit], the "HI" symbol will be on. Set the high limit in
3)
the same way the low limit was set. Pressing the [Tare] key to enter the value will
return the scale to weighing, with the Check-weighing function enabled.
To disable the check weighing function, enter zero into both the limits as described
4)
above. When the current limits are shown, press [CE] to clear the settings, then press
[Tare] ↵ to store the zero values.
NOTE: The weight must be greater than 20 scale divisions for the check-weighing to operate.
© Adam Equipment Company 2019 10